Toyota Archives - Positive Performance

2004 Toyota Camry
Mileage
84,553
Service Date
12/19/2024
Services Performed
Cross Directional Tire Rotation. Check and fill tires to specified air pressure.
Changed Motor Oil & Replaced Filter, Added 4 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels
JENNIFER T. gave our service a 5 star review on 12/27/2024
2018 Toyota C-HR
Mileage
76,635
Service Date
10/22/2024
Services Performed
Inspect Brakes
DISC ROTOR – Remove & Replace – Front,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
DISC ROTOR – Remove & Replace – Rear,Both – [Includes: Additional time for use of scan tool to perform this procedure.] – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
ANGEL G. gave our service a 5 star review on 10/23/2024
2004 Toyota 4Runner
Mileage
186,170
Service Date
10/22/2024
Services Performed
THERMOSTAT &/OR GASKET – Remove & Replace – V6
PCV VALVE – Remove & Replace – V6
Change oil and filter with 5.5 Quarts Synthetic oil
JOSHUA B. gave our service a 5 star review on 10/22/2024
2011 Toyota Sienna
Mileage
198,445
Service Date
9/10/2024
Services Performed
Test Drive. Checked front suspension and steering. Passenger cv axle is making noise and leaking grease. Also noted front struts are leaking and sway bar links have play. Recommend replacing passenger cv axle, front struts and sway bar links.
AXLE SHAFT – Remove & Replace – FWD Right Side – [DOES NOT include alignment. NOTE: For Independent Suspension Type Axles, this operation consists of removal and installation, dissassembly and reassembly of the Axle Shaft Assembly and replacement of the A
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment.]
STABILIZER BAR CONTROL LINK – Remove & Replace – Both
JUDIE S. gave our service a 5 star review on 9/13/2024
2004 Toyota Camry
Mileage
77,495
Service Date
10/12/2023
Services Performed
BALL JOINT & DUST COVERS – INSPECT – [Check the suspension and steering linkage ball joins for looseness and damage. Check all dust covers for deterioration and damage. Replace any deteriorated or damaged parts.] BRAKE DRUMS & LININGS – INSPECT – [Check the brake linings (shoes) and drums for scoring, burning, fluid leakage, broken parts and excessive wear. Replace any deteriorated or damaged parts.] BRAKE HOSES – INSPECT – [Visually inspect for proper installation. Check for chafing, cracks, deterioration and signs of leaking. Replace any deteriorated or damaged parts.] BRAKE LINE PIPES – INSPECT – [Visually inspect for proper installation. Check for chafing, cracks, deterioration and signs of leaking. Replace any deteriorated or damaged parts.] BRAKE PADS – INSPECT – [Check pads for excessive wear. Replace any deteriorated or damaged parts.] DISC BRAKES – INSPECT – [Visually inspect discs. Replace any deteriorated or damaged parts.] DRIVE BELTS – INSPECT – [Inspect for cracks, excessive wear and oiliness. Check the belt tension and adjust if necessary. Replace the belts if they are damaged.] DRIVESHAFT/PROPELLER SHAFT DUST BOOTS – INSPECT – Drive Shaft Boots – [Check the drive shaft boots and clamps for cracks, deterioration and damage. Replace any deteriorated or damaged parts and, if necessary, repack the grease.] ENGINE COOLING SYSTEM HOSES & CLAMPS – INSPECT EXHAUST PIPES & MOUNTS – INSPECT – [Visually inspect the exhaust pipes, muffler and hangers for cracks, deterioration and damage. Start the engine and listen carefully for any exhaust gas leakage. Tighten connections or replace parts as necessary.] STEERING GEAR/RACK – INSPECT – [Check for damage/leaks.] STEERING LINKAGE & BOOTS – INSPECT – [With the vehicle stopped, check for excessive freeplay in the steering wheel. Inspect the linkage for bending and damage and the dust boots for deterioration, cracks and damage. Replace any damaged parts.] ENGINE OIL – REPLACE ENGINE OIL FILTER – REPLACE ENGINE OIL REPLACEMENT REMINDER LIGHT – RESET – [Reset the oil replacement reminder ("MAINT REQD") light after replacing engine oil, if vehicle is equipped with this light.] TIRES – ROTATE – [Check tire tread depth and for uneven or excessive wear.]
Changed Motor Oil & Replaced Filter, Added 4 QTS Standard Motor Oil, Lube Chassis, Check all Fluid Levels
JENNIFER T. gave our service a 5 star review on 10/12/2023
2020 Toyota Camry
Mileage
100,701
Service Date
9/18/2023
Services Performed
Diagnose Cause of Light
SPARK PLUGS – Remove & Replace – 2.5L Eng
MIGUEL C. gave our service a 5 star review on 9/18/2023
2006 Toyota Tundra
Mileage
229,065
Service Date
6/28/2023
Services Performed
Change oil and filter with 6.5 Quarts Synthetic oil
This vehicle's owner gave our service a 5 star review on 6/28/2023
2012 Toyota Tacoma
Mileage
157,733
Service Date
3/14/2023
Services Performed
R&R Driver front hub assembly
STEVE F. gave our service a 5 star review on 3/14/2023
2010 Toyota Tacoma
Mileage
134,205
Service Date
2/23/2023
Services Performed
Change oil and filter with 5.5 Quarts Synthetic oil
Cross Directional Rotate and Balance Four Tires
JERI B. gave our service a 5 star review on 2/23/2023
2015 Toyota Camry
Mileage
113,618
Service Date
12/8/2022
Services Performed
TRANSMISSION OIL PAN &/OR GASKET – Remove & Replace – Gas,In-Line4 w/o Engine Removal,w/o Transmission Removal – [NOTE: OEM Procedures state to remove the transmission to R&I this component. Several sources indicate removal and installation of this compon
Cleaned off transmission pan and found fluid accumulating on the right side of the pan. It appeared the pan had been removed and upon installation three of the bolts on the pan were over tightened and had blue loc-tite applied to the threads causing the gasket to leak. Also found the transmission mount was loose and not even hand tight. Recommend replacing transmission fluid, filter and gasket
JOHN P. gave our service a 5 star review on 12/8/2022

Toyota

We Service and Repair all Toyota cars